Fusbol Replacement Grip

For my project, I decided to create a replacement for the missing grip on the blue striker side on the IMA/ITP floor's fusbol table. It's been missing the grip since at least last year, and seeing how it's small enough to fit in the print area I thought it a good use of time to replace it. The process was fairly simple:

  1. Create two concentric cirlces, then pull exterior out to length and interior out slightly to create cap.
  2. Draw ellipse-shaped 2d side extrusions, then flip them through symmetry and rotation around the cylinder
  3. Fillet and chamfer down the edges to make the part more ergonomic
  4. Extrude out the top area at an angle to create a difference in shape to stop hand slipping.

Render of Part

In Progress Shot